Disc grinder (stone molar grinder)

working principle

A disc crusher grinds samples by the pressure and friction generated between one rotating disc and another fixed disc. The sample enters the grinding chamber and is pre crushed between two rough interlocking serrations before being transferred to the outer edge of the disc for further micro crushing. The ground sample falls into the sample receiving container through the gap of the grinding disc.

Product Features

·Easy to operate, wipe to clean, no risk of mixed material contamination

·The disc is formed as a whole, with high structural strength and a variety of materials for grinding discs to choose from

·Hard steel, manganese steel, tungsten carbide, zirconia, silicon carbide, etc

·The sample feeding size is large, up to 20-50mm

·Larger processing capacity compared to similar products

·The gap control mechanism is precise and can be used for a long time after calibration

·Automatic sampler can be configured for injection, and there is a dedicated container for material recovery

Application scenarios

① From block to tens of microns, one device can easily handle it

② Can be used as a pre grinding tool for the intake flow mill

③ One device can replace both jaw crusher and roller machine at the same time

④ The roller mill is used for line to line contact crushing, while the disc mill is used for surface to surface contact crushing. Compared to the roller mill, the disc mill has lower energy consumption and higher production capacity

⑤ Can replace the coarse crushing function of ball mills from block to tens of microns. Compared to ball mills, there is no need to screen vibrating balls, greatly improving crushing efficiency

Processing case

Sintered glass, silicates, various mineral powders, electronic component materials, semiconductor raw materials, advanced ceramics, magnetic materials, carbon materials, plants, grains, composite materials, rare earths, various metal oxides, battery materials, etc.